Foam gun

Instruction manual

1. Unscrew the cover
2. Select the measuring tip for the desired dosage using the table below and push the tip firmly into the suction tube at the bottom of the lid.
3. Fill the reservoir with concentrate.
4. Screw the lid back firmly onto the reservoir.

CAUTION: the lid must be firmly attached to the reservoir to prevent concentrate spillage when using the Foam-Boy.

1. Attach the lid to the gun's quick disconnect.
2. Attach the hose to the gun. Open the water supply to the hose (a water pressure of 1.76 bar is required for proper operation of the Clean-Boy).
3. To remove the cover with reservoir from the gun, take the gun's quick release in one hand and in the other. Then pull it apart. To flush, just disconnect the gun and insert the attached multi-jet spray nozzle into the gun's black coupler.

Mixing ratios vary according to the pressure, temperature, flow rate and viscosity of the product, as well as when you remove the bottom valve from the intake tube. The values below can be used as a guideline. The mixing ratios below were obtained at 2.67 Bar (40 PSI) pressure, with cold water (viscosity 1.0 cp).

Without 8:1 12.5%

Yellow 18:2 5.5%

Blue 24:1 4.0%

Green 40:1 2.5%